regarding question posted to you on7/18/2011, we have checked all fuses, which seem to be in working order (low beam headlights not working. fog and high beams do work) on 1999 Ford Mustang GT. no pow … read more Oil Warning Light. The EcoSport’s engine oil light comes on in red with an engine oil can symbol. The warning light popping up might be because of low engine oil level or low oil pressure. When you notice this light, stop your EcoSport as soon as possible, switch off the engine and check the oil level using the dipstick. Posts: 213. This message appeared on the display today. It has happened a couple of times in the past but disappeared when re starting the vehicle. Thought it to be a glitch but has happened four times today (well 8 when powering up and then when disabling the Ghost. It seems it happens with other ford models but the forums date back over 2 Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special Find some flat, level pavement next to a wall. With the nose of the Focus 25 feet from the wall and facing it squarely, measure from the ground to headlight center, (usually the chrome bulb cap inside the housing). Note that measurement, because you're going to mark the wall with tape horizontally at that height, minus two inches. 24 August 2018. Iain Kelly. Ford's Focus uses a Halogen H7 bulb in its low-beam socket. Open the bonnet and remove the two Torx screws holding the headlight in place, then lift the headlight forward and out of the car. Unplug the wiring connector on the back, then remove the rubber boot weather seal on the back of the headlight. Position 0 = 11.5v (no engine running) Position 1 = 9.2v. Position 2 = 7.1v. Position 3 = 5.1v. Position 4 = 3.4v. Still the headlights don't adjust when turning the knob inside the car, i have repositioned the pins inside the headlight plug to match the plug on the car. Still nothing, everything else works a treat. Removing headlights on the car is a complete pain in the butt, first you have to remove the wheel arch linnings to get access to two Torx screws located on the top of the lip on the wing panels (2 scews each side) then you have the joy or completely removing the front bumper to get clear access to the headlight mounting screws. bb9uLGZ.